Sony Handycam DCR-VX700 Operation Manual page 26

FeSO se tad
j
i
)
d
26
e-recording a
Recorded Tape
You can re-record a scene in the middle of a recorded tape by setting the starting [a] and ending [b]
points. The previously recorded portion will be erased.
(1) Press START/STOP while recording.
The camcorder enters Standby mode.
(2) Hold down the +(forward) or -(reverse) side of EDITSEARCH until the camcorder goes to the
point where you want to end the insertion.
The camcorder enters Standby mode again [b].
(3) Press ZERO SET MEMORY.
The counter is reset to "0:00:00". "ZERO SET MEMORY" flashes, and the ending point is stored in
memory.
(4) Hold down the - side of EDITSEARCH until the camcorder goes back to the point where you want
to start the insertion [a].
The camcorder enters Standby mode again.
(5) Press START/STOP to start re-recording.
The insert recording stops automatically at the counter zero point, and the camcorder enters Standby
mode again. Zero set memory resumes automatically.
+ EDITSEARCH -©
Proc
a a: