Maintenance - Zenith LXG-120 User Manual

Zenith lxg-120: user guide
Hide thumbs Also See for LXG-120:
Table of Contents

Advertisement

Maintenance

The projector requires very little maintenance. You should keep the lens clean because any dirt or stains may
appear on the screen. Clean the air filter attached at the bottom of the projector periodically because a
clogged air filter prevents proper ventilation that is necessary to cool the projector and prevents it from over-
heating. If any parts need to be replaced, contact your service center.
When cleaning any part of the projector, always turn the power off and unplug the projector first.
Cleaning the lens
Cleaning the lens
Clean the lens if dirt or dust appears on the surface of it. Wipe the lens surface gently with a soft, dry lint-free
cloth, or use an air spray.
To remove dirt or stains on the lens, moisten a soft cloth with water and a neutral detergent and wipe the lens
surface gently.
Cleaning the Projector Case
Cleaning the Projector Case
To remove dirt or dust, wipe the casing with a soft, dry, lint-free cloth. To remove stubborn dirt or stains, moist-
en a soft cloth with water and a neutral detergent and then wipe the casing.
Do not use alcohol, benzene, thinners or other chemical detergents as these can cause damage to the case.
Cleaning the
Cleaning the
Air Filter
Air Filter
The air filter, which is located at the bottom of the projector, should be cleaned after every 100 hours of use.
If it is not cleaned periodically, it can become clogged with dust and prevent the projector from being ventilat-
ed properly. This may cause overheating and damage of the projector.
To clean the air filter :
1. Stand the projector on its side so that the handle is on the top, and you can easily access the air filter.
2. Push the opening tip of the air filter cover and remove the cover.
3. To clean the filter, use a small vacuum cleaner designed for computers or other office equipment. Or you
may use a dry, lint-free cloth.
If it is difficult to remove dirt or the filter is torn, contact your the service center for replacement.
5. Close the filter cover after cleaning.
42

Advertisement

Table of Contents
loading

Table of Contents