Radio Operation; Presetting The Radio Stations - Zenith DA3520 Operating Manual

Presetting the radio stations

You can preset 30 stations for FM and AM.
Before tuning, make sure that you have turned
down the volume to the minimum.
1 3 4, 6
1
2
3
4
2 5
5
6
7
To tune in a station with a weak signal
Press TUNING/SKIP
in the station manually.
To clear all the memorized stations
Press and hold MEMORY for about three seconds and
"CLEAR ALL" appears in the display window and then
press MEMORY again, the stations are cleared.
For your reference
If all stations have already been entered, MEM FULL message
will appear in the display window for a moment and then a
preset number will flash. To change the preset number, follow
the steps 5-6 as above.

RADIO OPERATION

Press FUNCTION on the front panel repeated-
ly or FM/AM on the Remote control until the
FM or AM appears in the display window.
And then every time you press FM/AM, FM
and AM changes alternately.
Press and hold TUNING/SKIP
the front panel for about two seconds until
the frequency indication starts to change,
then release.
Scanning stops when the DVD Receiver tunes in a
station. "TUNED" and "STEREO" (for stereo program)
appear in the display window.
Note: TUNED only appears when the signal is FM and
STEREO.
Press MEMORY.
A preset number will flash in the display window.
D D E E
Press or on the front panel to select the
preset number you want.
Press MEMORY again.
The station is stored.
Repeat steps 3 to 6 to store other stations.
or repeatedly in step 3 to tune
PAGE 31
or on