Installation - Electrolux IK206520RE User Manual

Problem
The temperature in
the refrigerator is
too high.
The temperature in
the freezer is too
high.
There is too much
frost.
Upper or lower
square is shown in
the temperature dis-
play.
dEMo appears on
the Display.
6.1 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service Cen-
ter .
6.2 Closing the door
1.
Clean the door gaskets.

7. INSTALLATION

WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
Possible cause
There is no cold air circu-
lation in the appliance.
Products are too near to
each other.
Food is not wrapped cor-
rectly.
The door is not closed
correctly.
The temperature regulator
is not set correctly.
An error has occurred in
measuring the tempera-
ture.
The appliance is in dem-
onstration mode (dEMo).
2.
3.
7.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Solution
Make sure that there is cold
air circulation in the appli-
ance.
Store products so that
there is cold air circulation.
Wrap the food correctly.
Refer to "Closing the door".
Set a higher temperature.
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not be
possible).
Keep pressed approximate-
ly 10 sec. theOK button
since a long sound of buz-
zer is heard and the Display
shut off for a short while:
appliance start works regu-
larly.
If necessary, adjust the door. Refer to
"Installation".
If necessary, replace the defective
door gaskets. Contact the Service
Center.
ENGLISH 61