6
Put the black calibration box on the sensor
area (below the square side) and push the
rubber by applying force with your finger.
Tap Next and keep pushing the rubber
with your finger until you see the success
message.
The black calibration box must be
•
prepared before you start.
The bottom side of the rubber that is
•
shaped like a square should be located
on the square guide line
7
Put the 3D fingerprint dummy rubber on
the sensor area (below the square side) and
push the rubber by applying force with your
finger.
Tap Next and keep pushing the rubber
with your finger until you see the success
message.
The 3D fingerprint dummy rubber
•
must be prepared before you start.
The bottom side of the rubber that is
•
shaped like a square should be located
on the square guide line. (Do not place
the pattern horizontally on the 3D
fingerprint dummy rubber.)
Calibrations
33