Camcorder Connected To Vcr - Zenith VRB210 Operating Manual

Camcorder Connected to VCR

This page describes how to connect a camcorder to your VCR.
Back Panel of Stereo VCR
R-AUDIO-L VIDEO
OUT OUT
CH3 CH4
IN IN
A/V cable is not provided with VCR.
Select AUX for Viewing an Audio/Video source like a
Camcorder
1. With TV and VCR on, place VCR in VCR mode by pressing the
TV/VCR button on the remote (and repeat) until the VCR
indicator light appears in the VCR's front panel.
2. Select channel 3 (or 4) on the TV. Note: If your TV has A/V
jacks, you may get a better picture if you connect your VCR
there. (Then, select the A/V source on the TV.)
3. At the VCR, Channel down lower than the lowest channel (or
Channel up above the highest) to select "AUX". You can also
choose the SETUP menu as described in "How to Access
Menus" on page 9.
Press 3 for the SETUP menu's SOURCE item.
Press 3 for AUX, then ENTER. (Press QUIT to exit.)
Items in the Menu
SOURCE Shows the program source—TV, CATV, or AUX—selected for the VCR to receive.
TUNER The VCR is using its Tuner to receive programs from an antenna or cable.
TV Selects programs for the VCR from a rooftop-type antenna.
CATV Selects programs for the VCR from Cable TV.
AUX Selects programs for the VCR from the R-AUDIO-L—VIDEO IN jacks (where you may have connected your
camcorder).
ANT
IN
VHF/UHF/CATV
OUT
TO
TV
O P E R AT I O N
Turn off power or unplug VCR
before making any connections.
SETUP MENU
SOURCE: TUNER (TV)
1 TV 2 CATV
3 AUX
Press number keys
then ENTER QUIT = exit
Press 3 to select AUX
P A G E 2 1