Canon Arizona 6100 XTHF Mark II Series User Manual page 66

Print Job Control Module
Move Gantry
Raise Gantry
Start
Nozzle check
6) Active Print Job List
The active job list consists of a table, job count summary on top and job order control buttons on
the left. A job count summary displays total number of active jobs and number of jobs put on
hold. Job order control buttons can be used to change order of jobs queued for printing. The
active job list has the following features:
• All incoming jobs issued from the ONYX workflow go directly into the active job list.
• After a job is printed it automatically moves from the active to the inactive job list.
• The operator can drag and drop jobs to move them between the active and inactive job lists
(except for a job that is being prepared to print).
• All the jobs are stored locally on the printer hard drive.
• Selecting a job highlights the job and updates the job information area.
• Jobs can be moved up/down in the active list using the button on the left. Jobs can either be
printed, held, canceled or deleted. Jobs canceled from the active list are moved to the inactive
list.
• Deleted jobs are removed from the hard drive and are no longer accessible (except for Special
Prints, which cannot be deleted).
• The current job being printed can be paused or canceled. A canceled job will move from the
active to the inactive print job list.
• A job count summary displays the total number of active and inactive jobs and the number of
active jobs on hold.
7) Job Placement Preview
The table placement preview shows the print location and a proportional representation of the
image in relation to the table. The zoom button in the bottom right corner activates a popup
preview window. If a preview image is not available, an approximately sized white box is used as
a placeholder, and the zoom button is not displayed.
The preview image can be positioned by dragging it around the window (this will automatically
update the offsets fields).
66 Chapter 3 - How to Navigate the User Interface
This moves the gantry from its parked position to a new location. Pressing
the icon again moves the gantry back to its home position. The Custom
gantry park position can be selected by the operator in the Settings tab. It
determines the distance the gantry moves.
This raise the gantry to allow placement of media that is too thick to fit un-
der the default height. Before a print begins the gantry is set back to its op-
erating height.
This icon can be used to start a flatbed print job (same function as the
physical button on the table).
NOTE
Use of the Pause/Resume button may cause artifacts in a print
because of the uneven curing of the ink if the job is paused. Do
not use this unless it is essential that the print job is paused.
This icon populates the active job list with a job that prints a nozzle check
pattern. The nozzle check print is used to identify nozzle dropouts that can
cause banding and other print quality problems.
NOTE
For information on how to use the nozzle check to troubleshoot
nozzle dropouts, see
Checking Nozzle Performance on page
154.