Hook Up Cable Service (Catv) And Vcr - Zenith D27D53T Operating Manual & Warranty

Hook Up Cable Service (CATV) and VCR

Connect Cable service and a VCR to the TV
Locate the Antenna/Cable In jack on the
1
back of the VCR.
2
Connect the cable service wire that runs
from the wall, according to one of the dia-
grams to the right. Make any other connec-
tions necessary for your setup.
3
Remove the back of the remote and put in
two "AA" batteries.
Back of
Remote
4
Plug in the TV. Do not plug it into an outlet
controlled by a switch. The TV is designed to
operate on standard current, 120-volt 60
Hertz AC. Do not attempt to operate it on
DC power.
Tune both the VCR and the television to channel 3
or 4 (cable box output channel) and use the cable
box to change channels.
No A/V cables are included with your TV. Without
A/V cable hookups, most VCRs will not play
videocassettes in stereo sound.
206-3594
Typical
Cable TV
Wall Jack
Cable Box
In
output
Out switch 3 4
Cable service
with or without
a cable box
Typical
Cable TV
Wall Jack
P
COMPUTER
INPUT
P
HD/COMPUTER
R
VCR Back
VCR Back AV Panel
output
In
switch
Out
Audio Video
TV Back
Y
Y
C
R R
C
B
B
R
R R
L
L
L
L
Connect your VCR to the
Video 1 or Video 2 set of input jacks
3 4
R
L
P A G E 1 1