Zenith C19A21D Operating Manual & Warranty page 9

Hook Up Your Cable (CATV) and VCR
Connect cable service and a VCR to your
Entertainment Machine.
Locate the Antenna/Cable jack on
1
the back of your Entertainment
Machine.
Connect the cable that runs from
2
the wall directly to this jack,
according to the diagram to the
right.
Remove the back of the remote
3
and put in two AA batteries.
Plug in your TV. Do not plug it
4
into a switched outlet. Your
Entertainment Machine is
designed to operate on household
current, 120-volt 60 Hertz AC do
not attempt to operate it on DC
Current.
Go to page 10 to Auto Program
5
your Entertainment Machine.
Leave your VCR and your television
tuned to channel three and use
the cable box to change channels.
Remember, when screwing in RF
cables onto jacks, clockwise tight-
ens, and counterclockwise loosens.
Without A/V cables, most VCRs will
not play videocassettes in stereo
sound.
2 0 6 - 3 5 8 5
back of
remote
Cable with VCR to
Entertainment Machine
Cable TV
wall jack
RF coaxial cable (75 ohm)
TV back
TV back panel
(expanded view)
Audio
Video
R L
Antenna
Cable
A/V cables
not included
with TV
Cable TV Cable with Cable Box to VCR and
wall jack
Entertainment Machine
Cable box
In
output
Out
switch 3 4
RF coaxial cable (75 ohm)
TV back
RF coaxial wire
TV back panel
(expanded view)
Audio
Video
R L
Antenna
Cable
A/V cables
not included
with TV
VCR back
VCR back AV panel
output
In
switch 3 4
Out
Video
Audio
RF coaxial wire
(75 ohm)
not included
with TV
VCR back
VCR back AV panel
output
In
switch 3 4
Out
Video
Audio
(75 ohm)
not included
with TV
P A G E 9