Vcr Hookup - Zenith B50M88W Operating Manual & Warranty

VCR
Locate the RF or VHF/UHF/CATV In jack on
1
the back of your VCR. Connect the cable
line coming from your wall directly to
this jack.
Find the composite video and audio
2
jacks on the back of your VCR, and con-
nect them following the instructions
provided with your equipment.
You may connect either the composite
video or the S-video cables to your
Entertainment Machine. (Do not con-
nect BOTH the composite and the S-
Video cables. In the event that you
connect both composite and the S-
Video cables, only the S-video will
work.)
To hear stereo sound from cable or your VCR,
you will need to connect A/V cables as well as
the wire that runs from the VCR to your
Entertainment Machine.
If you want to receive your signals on Channel
3 or 4, locate the Out to TV jack on your VCR.
Connect a cable from the Out to TV jack to the
Antenna/Cable jack on the back of your
Entertainment Machine.
You will need to connect a VCR to your
Entertainment Machine if you wish to use your
Picture-In-Picture (PIP) feature. (See page 38)
P A G E 1 0
Antenna
Cable TV
wall jack
OR
RF coaxial wire
(75 ohm)
Round wire
(75 ohm)
VCR
Back AV panel
In
3 4
Out
S-Video
Audio Video
STOP
CONNECT ONLY 8 ohm SPEAKERS
DO NOT SHORT CIRCUIT
THESE TERMINALS
(Such damage is NOT COVERED
by your television warranty.)
SURROUND / EXTERNAL SPEAKERS
8 ohm ONLY
ANTENNA
CABLE
INPUT
SURROUND
EXTERNAL
A/V cables
not included
with TV
S-VIDEO 1 S-VIDEO 2 COMPONENT IN
( Cr )
( Y ) ( Cb )
VIDEO
VIDEO 1 VIDEO 2
L/MONO L/MONO
AUDIO
AUDIO AUDIO
INPUT 1 INPUT 2
MONITOR OUT
VARIABLE
AUDIO OUT
206-3507-O