Programming The Remote - Zenith B27A34Z Operating Manual

Programming the Remote

Set up your remote to operate other brand name devices
1
Turn on the device you want to program.
On the chart on page 42/43, find the type of device you're
2
programming, and then find the brand name. Make a note of
the three-number code, you'll need it soon.
3
Press and hold PRG. It's recessed so it doesn't get pushed
accidentally. Use a small, blunt object. When the indicator
light turns on, you can release PRG.
4
Push the key name with the type of device you're program-
ming (VCR, CABLE, AUX, TV).
5
Using the NUMBER keypad, enter the three-number code you
found on page 42/43.
6
Press ENTER to save the code. (The indicator light will flash
3 times, then turn off to indicate the code is valid.)
7
Point the remote at the device and push POWER. It should
turn off. If not, try the other codes listed and continue from
step three.
Note: To reset remote to factory settings, enter 9-1-1, in
Step 5.
Programming your Zenith remote may allow you to use one remote
to work up to 7 different devices.
Not all devices will work with your Zenith remote control.
Mini glossary
PROGRAMMING Procedure to set up remote to operate other equipment.
PRG Programming mode key.
DEVICE Infra-red remote controllable electronic accessory equipment.
P A G E 3 8
Indicator Light
3
PRG
CABLE VCR AUX
SURF
FLASHBK
CHANNEL
VOLUME
CHANNEL
5
1 2
4 5
7 8
0
ENTER
MENU
RECORD PAUSE TIMER
PLAY
REWIND
STOP
7
POWER
4
TV
MUTE
VOLUME
3
6
9
6
QUIT
TV/VCR
SOURCE
FFWD
206-3481