Zenith B25A11Z Operating Manual page 9

Hook Up Your Cable (CATV) and VCR
Connect cable service and a VCR to your
Entertainment Machine.
Locate the Antenna/Cable jack on
1
the back of your Entertainment
Machine.
Connect the cable that runs from
2
the wall directly to this jack,
according to the diagram to the
right.
Remove the back of the remote
3
and put in two AAA batteries.
back of
remote
Plug in your TV. Do not plug it
4
into a switched outlet. Your
Entertainment Machine is
designed to operate on household
current, 120-volt 60 Hertz AC do
not attempt to operate it on DC
Current.
Go to page 10 to Auto Program
5
your Entertainment Machine.
Leave your VCR and your television
tuned to channel three and use
the cable box to change channels.
Remember, when screwing in RF
cables onto jacks, clockwise tight-
ens, and counterclockwise loosens.
Without A/V cables, most VCRs will
not play videocassettes in stereo
sound.
206-3477
Cable TV
wall jack
RF coaxial cable (75 ohm)
TV back
TV back panel
(expanded view)
Audio
Video
R
Antenna
Cable
Cable TV
Cable with Cable Box to
wall jack
Entertainment Machine
with VCR
Cable box
In
output
Out
switch 3 4
RF coaxial cable (75 ohm)
TV back
RF coaxial wire
TV back panel
(expanded view)
Audio
Video
R L
Antenna
Cable
Cable to
Entertainment Machine
with VCR
VCR back
VCR back AV panel
output
In
switch
Out
Video
RF coaxial wire
(75 ohm)
not included
with TV
L
A/V cables
not included
with TV
VCR back
VCR back AV panel
output
In
switch
3 4
Out
Audio
Video
(75 ohm)
not included
with TV
A/V cables
not included
with TV
3 4
Audio
P A G E 9