Zenith B25A11Z Operating Manual page 6

Hook Up Your Antenna to the TV
Connect an antenna to your Entertainment Machine.
Locate the Antenna/Cable jack on
1
the back of your Entertainment
Machine.
Connect the cable that runs from
2
the wall directly to this jack,
according to the diagram to the
right.
Remove the back of the remote
3
and put in two AAA batteries.
back of
remote
Plug in your Entertainment
4
Machine.. Do not plug it into a
switched outlet. Your
Entertainment Machine is
designed to operate on household
current, 120-volt 60 Hertz AC do
not attempt to operate it on DC
Current.
Go to page 10 to Auto Program
5
your Entertainment Machine.
If you have a 75 ohm RF cable,
then you don't need any adapters!
Remember, when screwing RF
cables onto jacks, clockwise tight-
ens, and counterclockwise loosens.
Mini glossary
75 OHM RF CABLE
300 TO 75 OHM ADAPTER
P A G E 6
The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of you
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an
inch long with two screws on one end and a round opening with a wire sticking out on the other end.
Flat wire antenna
to Entertainment Machine
Antenna
Flat wire
(300 ohm)
300/75 ohm
Adapter
Antenna to Entertainment
Machine Coaxial wire
Antenna
RF coaxial wire
(75 ohm)
Entertainment Machine
TV back
TV back panel
(expanded view)
Audio
Video
R L
Antenna
Cable
TV back
TV back panel
(expanded view)
Audio
Video
R L
Antenna
Cable
.
206-3477