Antenna - Zenith B19A23DC Operating Manual

Hook Up Your Antenna to the TV
Connect an antenna to your Entertainment Machine.
Locate the Antenna/Cable jack on
1
the back of your Entertainment
Machine.
Connect the cable that runs from
2
the wall directly to this jack,
according to the diagram to the
right.
Remove the back of the remote
3
and put in two AAA batteries.
back of
remote
Plug in your Entertainment
4
Machine. . Do not plug it into a
switched outlet. Your
Entertainment Machine is
designed to operate on household
current, 120-volt 60 Hertz AC do
not attempt to operate it on DC
Current.
Go to page 12 to Auto Program
5
your Entertainment Machine.
If you have a 75 ohm RF cable,
then you don't need any
adapters!
Remember, when screwing RF
cables onto jacks, clockwise
tightens, and counterclockwise
loosens.
Mini glossary
75 OHM RF CABLE
300 TO 75 OHM ADAPTER
206-3480
The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of you
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an
inch long with two screws on one end and a round opening with a wire sticking out on the other end.
Flat wire antenna to
Entertainment Machine

Antenna

TV back panel
(expanded view)
Flat wire
(300 ohm)
300/75 ohm
Adapter
Antenna to
Entertainment Machine
Antenna
RF coaxial wire
(75 ohm)
TV back
OUT
R Audio L/Mono
ANT IN
75
IN
TV back
OUT
R Audio L/Mono
ANT IN
75
IN
Entertainment Machine
.
P A G E 7
Video
Video