Zenith A27A74R Operating Manual page 7

Hook Up Your VCR and Cable (CATV)
Locate the Antenna/Cable jack on
1
the back of your Entertainment
Machine.
Connect the cable that runs from
2
the wall directly to this jack,
according to the diagram to the
right.
Remove the back of the remote
3
and put in two AAA batteries.
back of
remote
Plug in your TV. Do not plug it
4
into a switched outlet. Your
Entertainment Machine is
designed to operate on household
current, 120-volt 60 Hertz AC do
not attempt to operate it on DC
Current.
Go to page 11 to Auto Program
5
your Entertainment Machine.
Leave your VCR and your television
tuned to channel 3 and use the
cable box to change channels.
Remember, when screwing in RF
cables into jacks, clockwise tight-
ens, and counterclockwise loosens.
No A/V cables are included with
your Zenith Entertainment
Machine, but can be purchased in
most consumer electronics stores.
Without A/V cables, most VCRs will
not play videocassettes in stereo
sound.
206-3372-A
Cable TV
wall jack
RF coaxial cable (75ohm)
TV back
RF coaxial wire
(75 ohm)
Antenna
Variable
/Cable
Audio Out
R L
A/V cables
not included
S-Video Video
with TV
R-Audio L/Mono
Cable TV
wall jack
Cable box
In
output
Out
switch
3 4
VCR back AV panel
RF coaxial cable (75 ohm)
Out
TV back
RF coaxial wire
(75ohm)
not included
with TV
Antenna
Variable
/Cable
Audio Out
R L
A/V cables
not included
S-Video Video
with TV
R-Audio L/Mono
I N S TA L L AT I O N S TA N DA R D
VCR back
VCR back AV panel
output
In
3 4
switch
Out
Audio Video
not included
with TV
VCR back
output
In
switch
3 4
Audio Video
P A G E 7
Connect your
VCR and Cable
to your
Entertainment
Machine.