Zenith A27A74R Operating Manual page 6

P A G E 6 I N S TA L L AT I O N
Hook Up Your Antenna and VCR to TV
Connect an
off-air
antenna and
VCR to your
Entertainment
1
Machine.
2
3
4
5
S TA N DA R D
Locate the Antenna/Cable jack on
the back of your Entertainment
Machine.
Connect the cable that runs from
the wall directly to this jack,
according to the diagram to the
right.
Remove the back of the remote
and put in two AAA batteries.
back of
remote
Plug in your TV. Do not plug it
into a switched outlet. Your
Entertainment Machine is
designed to operate on household
current, 120-volt 60 Hertz AC do
not attempt to operate it on DC
Current.
Go to page 11 to Auto Program
your Entertainment Machine.
Remember, when screwing
RF cables into jacks, clockwise
tightens, and counterclockwise
loosens.
No A/V cables are included with
your Zenith Entertainment
Machine, but can be purchased in
most consumer electronics stores.
Without A/V cables, most VCRs
will not play videocassettes in
stereo sound.
Antenna
Flat wire
(300 ohm)
300/75 ohm
Adapter
TV back
RF coaxial wire
(75ohm)
not included
with TV
Antenna
Variable
/Cable
Audio Out
R L
S-Video Video
A/V cables
not included
with TV
R-Audio L/Mono
Antenna
RF coaxial cable
VCR back AV panel
(75 ohm)
TV back
RF coaxial wire
(75ohm)
not included
with TV
Antenna
Variable
/Cable
Audio Out
R L
A/V cables
not included
with TV
S-Video Video
R-Audio L/Mono
VCR back
VCR back AV panel
output
In
switch
3 4
Out
Audio Video
VCR back
output
In
switch 3 4
Audio Video
Out
206-3372-A