Table of Contents
Advertisement
Cleaning and care
Inserting the plinth filter
Fit the filter back on the handle. Make
sure it is the correct way round.
To ensure that the filter is positioned
correctly in the front of the heat ex-
changer unit:
First insert the handle with the plinth
filter attached over the two guide
pins.
– The word Miele on the handle must
be the correct way up.
Push the plinth filter in completely.
This will push in the right-hand guide
pin at the same time.
Close the heat exchanger access
panel.
42
Damage or ineffective drying if
drying takes place without a plinth
filter or when the heat exchanger ac-
cess panel is open.
An excessive accumulation of fluff
can damage the dryer in the long
term. If the system is not leak-tight,
this can make the drying ineffective.
You may only operate the dryer with
the plinth filter fitted correctly and the
heat exchanger access panel closed.
Advertisement
Table of Contents
