Panasonic UB-5315 Operating Instructions Manual page 18

Paper Jams
4
If the flashing " " does not go out after the foregoing procedure has been performed; this may indicate that the
paper feeder is not functioning properly.
Reload the copy paper by following the steps given below.
1
2
18
Install the thermal transfer film.
• Refer to steps 3 and 4 in the section of "Installing the
Thermal Transfer Film" on pages 10, 11.
• " " flashing on the Multi-Copy/Error Indicator will go
out.
Notes
• If " " is still flashing after closing the printer door,
make sure that the thermal transfer film has been
installed properly and tightened.
• The printer door should be closed to make copies
properly. Confirm both latches are locked.
Turn the power off.
ON
OFF
Open the paper cover and remove all the copy
paper remaining inside the unit's paper cover.
Note
• The copy paper will slightly resist being removed, but
may be pulled out without problems.