Table of Contents
Advertisement
en Disposal
Fault
Appliance does not
heat up.
The time is not dis-
played when the ap-
pliance is switched
off.
Home Connect is not
working properly.
The interior lighting
does not work.
Maximum operating
time reached.
Error code made up
of letters and num-
bers appears on the
display, e.g. E0111.
The cooking result is
not satisfactory.
24 Disposal
24.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
1.
Unplug the appliance from the mains.
32
Cause and troubleshooting
Demo mode is switched on.
1.
Briefly disconnect the appliance from the power supply by switching the circuit breaker in
the fuse box off and then on again.
2.
Switch off demo mode in the basic settings within approx. 5 minutes.
→ "Changing the basic settings", Page 20
There has been a power cut.
▶
Open and close the appliance door once after a power failure.
a The appliance is checked and is ready to use.
Basic setting has been changed.
▶
Change the basic setting for the time display.
→ "Basic settings", Page 19
Different causes are possible.
▶
Go to www.home-connect.com.
Basic setting has been changed.
▶
Change the basic setting for the lighting.
→ "Basic settings", Page 19
The LED light is defective.
▶
Call
→ "Customer Service", Page 33.
To prevent an unwanted permanent operation, the appliance automatically stops heating
after several hours if the settings are unchanged. A message appears in the display.
The point at which the maximum operating time is reached is determined by the corres-
ponding settings for an operating mode.
1.
To continue operation, switch the appliance off and on again using
the operation.
2.
If you do not need to use the appliance, press
Tip: To prevent the appliance from switching off when you do not want it to, set a cooking
time.
→ "Time-setting options", Page 13
The electronics have detected a fault.
1.
Switch the appliance off and on again.
a If the fault was a one-off, the message disappears.
2.
If the message appears again, call the after-sales service. Please specify the exact error
message when calling.
→ "Customer Service", Page 33
Settings were unsuitable.
Adjustment values, e.g. temperature or cooking time, depend on the recipe, quantity and
food.
▶
Next time, set lower or higher values.
Tip: A lot of other information about the food preparation and corresponding adjustment
values can be found in the Home Connect app or on our website www.bosch-home.com.
to switch it off.
2.
Cut through the power cord.
3.
Dispose of the appliance in an environmentally
friendly manner.
. Reset and start
Advertisement
Table of Contents
