Kawai DATACAT Owner's Manual page 5

@ BENDER (PITCH BEND) WHEEL
Sends MIDI PITCH BEND messages to connected MIDI instruments.
@) WHEEL
The control information on p.10 is assigned to this WHEEL.
@ POWER button
Turns the DATACAT's power on and off. When the power is turned on, the LED lamp on the front panel
will light.
@ LED
Ensures you if the values are properly entered. If you are using batteries which are reaching the end of their
lifespan, the LED will begin to blink slowly (approximately every four seconds). At that time you should
replace all six of the batteries.
©) FUNCTION SWITCHES
These are pressed to set various functions (BANK, or WHEEL assignments; PROGRAM NUMBER
transmission; MIDI TRANSMIT channel; RESET ALL CONTROLLERS; or GM reset).
© TRANSPOSE SWITCHES
Used to set the TRANSPOSE value, and to shift the DATACAT's pitch by one octave higher and lower.
@ OCTAVE SHIFT SWITCHES
Used to set the TRANSPOSE value, and to shift the DATACAT's pitch up to four octaves higher and lower.
Numeric Keys
Used to set the value for all functions. If you make a mistake, press the CLEAR key and enter the correct
value from scratch.
@ MIDI OUT Jack
Outputs all of DATACAT's MIDI messages. Use a MIDI cable to connect the DATACAT to other MIDI
devices.
DC IN Jack
This jack is used to connect Power Adaptor (Kawai PS-092) available separately.
bh See page 3 for special instructions if you are using a universal AC adaptor or other brand of adaptor.
Of course, the keys in the Numeric keys section named above also function as a normal
keyboard when you are not in the settings mode.