Table of Contents
Advertisement
Connecting the Power Supply
Your keyboard can use either your home AC power outlet or dry cel] batteries as a power source.
B To insert batteries:
1. Turn the unit over and remove the battery cover.
2. Insert six Size "AA" dry cell batteries. Be sure they are aligned in the proper direction.
3. Replace the battery cover.
<> As the batteries begin to run down, the LED will begin to blink slowly (approximately every four
seconds). At that time, you should replace all six of the batteries.
Do not mix battery types (or new batteries with old ones), as this may cause problems such as battery
fluid leakage.
Remove the batteries when not using the keyboard for long periods of time.
M@ To Use An AC Power Outlet:
Connect a PS-092 adaptor (available separately) to the adaptor terminal on the rear panel of the
keyboard. Then, connect the adaptor to a wall socket.
<P We recommend that you use a KAWAI AC adaptor (9-volt/500 mA) with the DATACAT. If you decide
to use a universal adaptor from another manufacturer, please be sure of the following:
—
. The voltage selector should be set at 9-volts.
2. The polarity selector must be set to "negative" (—) polarity, otherwise the keyboard will not operate (or
will run on batteries until the batteries are drained).
3. The adaptor must have 0.5 Amp (A).
SPECIFICATIONS
KEYBOARD
37 Keys
FUNCTIONS
SETTING THE MIDI TRANSMIT CHANNEL
(1 - 16), WHEEL
ASSIGN, OCTAVE
SHIFT, TRANSPOSE,
SENDING
A PRO-
GRAM CHANGE NUMBER (0 - 127), BANK SELECT (0 - 16,384),
RESET ALL CONTROLLERS, GM RESET
JACKS
DC IN, MIDI OUT
DIMENSIONS (mm)
496 (W) x 197 (D) x 62 (H)
WEIGHT (kg)
1.6
Advertisement
Table of Contents
