Table of Contents
Advertisement
Ol ome
i
060 GOOG
co
"Editing" consists in taking pre-recorded tapes, combining various material into one part, cutting out the parts which are not
desired and connecting only what is required into a single program. There are two editing modes: assemble and insert.
Complete the operations listed below before proceeding with editing.
(CTL editing is the type of editing which is possible when only this unit is used for editing. Time code editing is not possible.)
71.
Complete the adjustments and settings (see page E-21 to page E-23).
2.
Check whether the FRAME LOCK lamp lights when the
following steps are taken.
[1]
Playback the tape which is to be edited.
[2]
Use the TRACKING control on the source unit so that the TRACKING meter pointer deflects to
its maximum.
[3]
Set the TRACKING control on the editor to its center clickstop position.
[4]
Set the "FRAME SERVO" (item No. 6005) dial menu function on the editor unit to "ON".
[5]
Check that the FRAME lamp at the source unit side has lighted.
M@ Ifthe lamp is off, set the "SYNC" (item No. 1001) dial menu function on the editor to "NORMAL".
[6]
Check that the FRAME lamp on the editor has lighted.
lf ifthe FRAME lamp is off, the edited pictures may be thrown into disarray.
3.
The material to be edited can be checked on the TV monitor.
Press the REC button while playback is in progress.
E-E pictures can be viewed while the REC button is depressed.
Signals are not recorded onto the tape.
e
E-E pictures cannot be viewed if a cassette has been inserted
without its accidental erasure prevention tab.
£24
Advertisement
Table of Contents
