Specifications; Intended Use; Power Supply - Makita LS1110F Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Model:
Blade diameter
Hole diameter
Max. kerf thickness of the saw blade
Max. miter angle
Max. bevel angle
No load speed (RPM)
Dimensions (L x W x H)
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Cutting capacities (H x W) with ø 260 mm saw blade
45° (left and right)
Symbols
The followings show the symbols which may be used
for the equipment. Be sure that you understand their
meaning before use.
Read instruction manual.
DOUBLE INSULATION
Wear safety glasses.
To avoid injury from flying debris, keep
holding the saw head down, after making
cuts, until the saw blade has come to a
complete stop.
When performing slide cut, first pull car-
riage fully and press down handle, then
push carriage toward the guide fence.
Do not place hand or fingers close to the
saw blade.
Adjust sliding fences clear of saw blade
and blade guard properly.
Do not stare at operating lamp.
European countries
Countries other than Europe
European countries
Countries other than Europe
Miter angle
0°
745 mm x 497 mm x 565 mm
45° (left)
50 mm x 310 mm
50 mm x 220 mm

Intended use

The tool is intended for accurate straight and miter
cutting in wood. With appropriate saw blades, aluminum
can also be sawed. For details, according to the section
for OPERATION.

Power supply

The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
13 ENGLISH
LS1110F
260 mm
255 mm - 260 mm
30 mm
25.4 mm
3.2 mm
Left 47°, Right 47°
Left 47°, Right 2°
-1
4,500 min
16.4 kg
/II
Bevel angle
0°
91 mm x 310 mm 85 mm x 310 mm
91 mm x 220 mm
Only for EU countries
Due to the presence of hazardous compo-
nents in the equipment, used electrical and
electronic equipment may have a negative
impact on the environment and human
health.
Do not dispose of electrical and electronic
appliances with household waste!
In accordance with the European Directive
on waste electrical and electronic equipment
and its adaptation to national law, used
electrical and electronic equipment should
be collected separately and delivered to
a separate collection point for municipal
waste, operating in accordance with the
environmental protection regulations.
This is indicated by the symbol of the
crossed-out wheeled bin placed on the
equipment.
2° (right)
-