Care And Cleaning; Washing The Motor Body - KitchenAid 5KHBC4 Series Owner's Manual

PRODUCT USAGE (CONTINUED)
5.
Press the LOCK switch to unlock the Professional Hand Blender, then press and hold the
POWER/PULSE Trigger to activate.
For best results, insert the Professional Hand Blender with the Whisk attached into the pot
or bowl containing ingredients at an angle. Use your free hand to hold the pot or bowl or
hold the Professional Hand Blender near the base of the motor unit for better stability.
Remember to stop the Professional Hand Blender before removing it from the pot or bowl
to avoid splashing.
Using a light circular motion from your wrist, draw the whisk up slightly and let it fall again
into the ingredients. Allow your wrist motion and the weight of the whisk to do the work.
Use the Removable Secondary Handle, if needed, for extra stability while mixing.
6.
When blending is complete, release the POWER/PULSE Trigger before removing the
Professional Hand Blender from the mixture.
7.
Unplug immediately after use, before removing or changing attachments. Blending Wrist
movement.
USING THE BOWL CLAMP AND THE CONTINUOUS RUN FEATURE
IMPORTANT: Continuous run feature maximum recommended mixing times:
30 minutes — Low Speed
10 minutes — High Speed
1.
Slide the notched latch into the Bowl Clamp at the slot in the top of the clamp; then use the
adjustment wheel to tighten into place at the correct spot for the bowl you are using to mix.
2.
Slide the Bowl Clamp over the edge of the Bowl you are using for mixing, allowing the
white notch on the clamp to snap onto the bowl; then, turn the knob to tighten in place.
3.
Snap the Professional Hand Blender into the slot at the bottom of the Bowl Clamp support
arm, so that the Professional Hand Blender is inserted in the mixture you are blending.
4.
Press the LOCK switch to unlock the Professional Hand Blender, then press the
POWER/PULSE Trigger and the continuous run button simultaneously, and then release
the POWER/PULSE Trigger to activate the continuous run feature. The Professional Hand
Blender will run hands-free at this setting.

CARE AND CLEANING

WASHING THE MOTOR BODY

IMPORTANT: Allow the appliance to cool completely before putting on or taking off parts, and
before cleaning the appliance.
NOTE: To avoid damage to the Professional Hand Blender, do not immerse the Motor Body in
washing solution, rinse water, or sanitizing solution.
Always clean the Professional Hand Blender prior to initial use, after each use, and before
storing.
1. Unplug the Professional Hand Blender before cleaning.
2. Remove the attachments by twisting (see "Product Usage" section).
3. Wipe the Motor Body and Power Cord with a warm, sudsy cloth; wipe clean with a damp
cloth. Dry with a soft cloth. Mild dish soap may be used, but do not use abrasive cleansers.
8