Recording On The H4Essential While Using It As An Audio Interface - Zoom H4essential Operation Manual

Recording on the H4essential while using it as an audio
interface
As explained in "Connecting to computers, smartphones and
being used as an audio interface if the Mode is set to "Audio I/F + REC". In this case, recording settings can
be made in the same way as when using it as a recorder.
See the references below and make recording settings.
Reference
Capturing audio before recording
starts (pre-recording)
Recording with levels adjusted on
the Mixer Screen
Enabling the recording start tone
Writing metadata (iXML chunks) to
recording files
NOTE
The sample rate of the H4essential itself cannot be changed when the Mode is set to "Audio I/F + REC" as
explained in "Connecting to computers, smartphones and
from the computer, smartphone or tablet. Then change the sample rate as explained in
rate".
HINT
Press to open the
The input signal is always buffered for a set amount of time, so it
can be captured (pre-recorded) for up to 2 seconds before the time
when
When recording, the levels of the sounds as input or the levels as
adjusted on the
Half-second tone signals (recording start tones) can be output from
the PHONE/LINE OUT jack when recording is started.
Various related information (metadata) stored in iXML chunks can
be written to recorded files.
where recorded files can be played back. (→
Playback Screen
tablets", the H4essential can record while it is
Explanation
is operated to start recording.
Mixer Screen can be used.
tablets". To change the sample rate, disconnect
96
"Setting the sample
Playing recordings)