Recording An Original Dynamic Vector - Yamaha SY-35 Getting Started Manual

Recording An Original
Dynamic Vector
3
Turn Vector Play ON
Now press the VECTOR PLAY [ON/OFF] key to turn the VECTOR PLAY
mode ON, and select [LEVEL] control.
Since Vector Play is ON, the dynamic vector will not play. Set the
VECTOR CONTROL to center position and play another note or chord.
You should hear all 4 elements at the same time, in approximately equal
proportions. Play with the VECTOR CONTROL a bit to get a feel for this
particular combination of elements.
VECTOR CONTROL
A
D
B
Now we'll go ahead and record an original dynamic level vector for the
SP * Bell voice.
1
Select the VOICE VECTOR Edit Mode
The first step is to enter the VOICE VECTOR edit mode, which we do by
pressing the [EDIT/UTILITY] key and then the [VOICE VECTOR] key.
2
Select the LEVEL SPEED Function
If the LEVEL SPEED function does not appear immediately when you
enter the VOICE VECTOR edit mode, press the [VOICE VECTOR] key a
few times until it does appear (Feature Reference manual, page 11).
VV>LEVEL SPEED
Vector Rate 30ms
A
C D
B
C
25