Advertisement
6
Pull out the speaker cable in the length of 15 to 16
cm from the speaker mounting bracket. Then attach
the speaker mounting bracket to the pole so that
the speaker cable fits to the cut in the pole. This
will lock the speaker cable. After that, fasten the
screw.
15–16 cm
Cut
Screw
7
Insert the pole to the support, and adjust the height
of the stand. After adjusting the height, fasten the
hexagon socket set screws into the two holes on
the support using the longer handle of the included
wrench, and attach the rubber cap to the support.
* The line on the pole shows the limit of the stand
height. Do not let the line of the stand height limit go
beyond the upper end of the support. Otherwise, the
hexagon socket set screw of the lower side becomes
ineffective and the fixation becomes unstable.
* Rubber cap
Hexagon
socket set
screw
Wrench
(hexagonal)
* The inside of the rubber cap has a space for
storing the wrench after the setup.
8
Adjust the speaker direction. Then put the wrench
into the hole of the speaker monting braket, and
tighten the bracket to the speaker by moving the
wrench counterclockwise.
9
Connect the speaker cable to the speaker's
terminals correctly.
* Refer to the instruction manual of the speakers for
10
Stand height
limit
The setup has completed.
Support
In the same way, set up the other stand.
Make sure to note the following when stretching or
shortening the pole after the setup.
● Make sure to remove the cable protection seal before
stretching or shortening the pole.
● When stretching the pole, pull out the pole carefully with
the speaker stand laying along.
● When shortening the pole, retract the pole carefully
while pulling out the speaker cable slowly by hand from
the base side with the speaker stand laying along.
connecting the speaker cables.
Align the speaker cable to the grooved part of
the bottom of the base, and fix the cable on the
base by putting the protection seal on it.
Cable
protection
seal
3
E-
Advertisement
