Advertisement
ASSEMBLY PROCEDURES
Before beginning assembly, check the parts list and make sure all the parts are included.
●
ASSEMBLY FIGURE
6
Plate
3
Pole
Limit of the stand
height
Support
Base
4
1
Speaker
Speaker
cable
6
3
5
2
2
4
1
●
PARTS LIST
NAME
1
+ self-binding tapping screws
(4 x 12)
2
Hexagon socket set screws
3
+ self-binding screws (4 x 8)
4
Pads
5
Wrench (hexagonal)
6
Gaskets
●
ASSEMBLY PROCEDURES
(You will need a screwdriver for assembly.)
1.
Attaching the base and support.
Pass the support through the hole from the bottom of the base,
and fasten the + self-binding tapping screws 1.
●
Fix the support so that the holes for the screws comes to the
rear side.
●
Do not overtighten the + self-binding tapping screws 1.
Doing so may damage the screws or assembly.
2.
Attaching the pole and support.
Insert the pole to the support, and fasten the hexagon socket
set screws 2 into the three hole on the support using the
included wrench 5.
●
The line on the pole shows the limit of the stand height. Do
not use the stand pulling out the pole above from this line.
The hexagon socket set screw 2 of the lower side becomes
ineffective and the fixation becomes unstable.
3.
Attaching the pads.
Put the pads 4 to the four corners on the bottom of the base to
prevent the stand from moving rickety.
4.
Attaching the gaskets.
Put the gaskets 6 to the both side of the plate.
5.
Wiring the speaker cables.
Insert the speaker cables to the hole on the plate, and aligned
them to the grooved part on the bottom of the base.
6.
Attaching the speakers.
Line up the holes on the bottom of the speaker and the center
hole on the plate, and fasten the + binding screws 3.
●
In order to ensure that the speakers do not fall, always hold
the speakers while attaching the speakers.
PARTS NOS.
QUANTITY
EP040090
12
VV249400
7
EG340360
4
VV249200
8
VV249500
1
VV249300
4
Advertisement
