Pioneer PD-M801 Operating Instructions Manual page 15

Programming a pause
Inserting a pause in your program can be very useful when carrying
out recording. Press il instead of entering a track number. "PA"
appears on the display panel.
e For example, when recording on both sides of a cassette tape,
if you program a pause after the last track to be recorded on
the first side, program playback will pause at that point to allow
you to switch tape sides. To resume program playback after the
player enters pause mode, press Hl.
Notes:
@ A pause can be programmed only when the program procedure
is performed under stop mode.
e@ A pause cannot be programmed at the beginning of a program
(P-01), nor can two pauses be programmed one after the other.
@ A pause inserted in a program is counted as one step.
e /f a pause is programmed as the last step of a program, the
player will not enter the pause mode.
To clear all of the program contents
® During stop mode, press ml.
When the magazine is ejected, the program contents will be
cleared.
To erase a program
During program mode, press CLEAR.
The last program step is erased and the contents of the previous
program step are displayed.
NOTE:
Contents of a program can be erased during playback as well.
However, tracks preceding the currently playing track cannot be
erased in this way.
TO PLAY ONLY DESIRED TRACKS/DISCS
To check the program contents
Ceca a ~ a
Fle «6 eer |
During program mode, set the player to stop mode and press
CHECK. The program contents will be displayed in the programmed
order.
e After confirming the last program step, the display will show
"0-00".
To modify the program contents
1
TRACK
NUMBER
1. During program mode, set the player to stop mode and press
CHECK so that the program step to be corrected appears on
the display.
2. To correct the disc No., enter the new disc No. with the DISC
NUMBER buttons. To correct the track No., enter the new
track No. with the Track number/Digit buttons. For example,
the programmed track No. 4 on the disc No. 3 is changed to
track No. 7 on the disc No. 5, using the DISC NUMBER 5 and
digit 7 buttons.
e Repeat steps 1 and 2 to change other tracks as desired.
@ To correct the track No., you can use kd or BPI button. After
selecting the track No., be sure to press PGM.
lf dor BRI is not pressed within 2 seconds when correcting
the track No., the displayed track No. is automatically memorized.
15
<PRB1174>
En