Table of Contents
Advertisement
Store Circuit Breaker
Notice
PRODUCT DAMAGE
e
Do
not
store
circuit
breaker
in
corrosive
environments above LC1 (sea salt mist) and Gil as
per ANSI/ISA-S71.04-1985.
NOTIC
F
Ensure circuit breakers are stored in a clean, dry
location, in their original packaging.
e
Failure to comply with these instructions may
result in product damage.
If you decide not to install the Retrofill breaker until a later time, then you can store it away
for installing it later.
1.
2.
Store the circuit breakers in a clean, dry location in an upright position.
Make sure that the breakers are properly supported to prevent bending of the studs or
damage to any of the breaker parts. Do not remove any protective grease until the
assemblies are ready to be installed. A covering of draft or other non-absorbent paper
prevents dust from settling on the breakers.
If breakers are not to be placed in service at once, remove them from their shipping
cartons and thoroughly inspect them for damage.
If everything is in satisfactory condition, replace the breakers in their shipping cartons
for storage. If it is necessary to store the equipment for any length of time, use the
following precautions to prevent corrosion or deterioration.
Store in a clean, dry, rodent-free location with moderate temperature and provide
protective coverings to prevent dirt, water, or other foreign substances from entering
the breaker.
If dampness or condensation is encountered in the storage location, heaters can be
used to prevent moisture damage.
After prolonged storage, Level 1 maintenance is needed under two years of storage.
While Level 2 maintenance is needed over two years of storage. Refer to circuit breaker
manual in maintenance L1-L2 descriptions.
Refer to
Emaxe2
Installation,
Operation
and
Maintenance
Instructions
— Publication
#1ISDHOO1000RO002 pages 99-112.
24] © 2020 Emax 2 Retrofill Circuit Breakers 800-5000A
2TSA451009P0000 Rev-B
Advertisement
Table of Contents
