Using The Magicstomp; Turn On The Amplifier And Play; Try Out Some Of The Other Patches - Yamaha Acoustic User Manual

Using the MAGICSTOMP

The MAGICSTOMP comes loaded with a variety of effect patches (programmed effects).
First, give some of the presets a try and see what's available.

Turn on the amplifier and play

You'll hear the currently selected patch.
Use the MAGICSTOMP's VOLUME knob to adjust the MAGICSTOMP's output volume.
Patch No.
Edit Icon

Try out some of the other patches

The MAGICSTOMP has a total of 198 patches. 99 of those are User Patches (U01 – U99) to which
you can save (overwrite) data of patches that you have created. The other 99 are Preset Patches
(P01 – P99) which can not be overwritten with new data. You can however, edit the Preset Patches
and save them in the User Patch section.
* When shipped from the factory, the AFR Function is set to ON, and the MAGICSTOMP's User Patch section
contains the same data as found in the Preset Patches.
* The effect type in all preset patches is set to AcousticMulti.
Two ways to select patches
When the MAGICSTOMP is shipped from the factory, its [UP/DOWN MODE] is already set for the
patch selection mode. In this mode, just press the + switch to move to the next greater patch number,
and press the – switch to move to the next lesser patch number. Hold either switch down and the
patch numbers will quickly cycle up or down in order.
Pressing the – switch decreases
the patch number by 1
12
• About the Edit Icons
Patch Name
The edit icons are used to indicate the currently selected
patch's condition.
,
,
AFR ON or Patch ON/OFF*
* The setting or effect type determines whether the switch will activate the Auto
Feedback Reduction function or switch the patch ON/OFF. (
... The patch's AFR function is active (
The icon appears when another parameter
is selected.
... The patch's AFR function is inactive (
23). The icon appears when another param-
eter is selected.
Pressing the + switch increases
the patch number by 1
page 23).
page
page 22)