M.2 Solid-State Drive - Lenovo ThinkPad X1 Carbon Gen 12 User Manual

M.2 solid-state drive

Follow the instructions to replace the M.2 solid-state drive.
Before you start, read
Generic Safety and Compliance Notices
Attention:
• If you replace a M.2 solid-state drive, you might need to install a new operating system. For details on how
to install a new operating system, see "Install a Windows operating system and drivers" on page 55.
The M.2 solid-state drive is sensitive. Inappropriate handling might cause damage and permanent loss of
data.
When handling the M.2 solid-state drive, remove or insert the M.2 solid-state drive horizontally. Otherwise
the slot might get damaged.
When handling the M.2 solid-state drive, observe the following guidelines:
• Replace the M.2 solid-state drive only for repair. The M.2 solid-state drive is not designed for frequent
changes or replacement.
• Before replacing the M.2 solid-state drive, make a backup copy of all the data that you want to keep.
• Do not apply pressure to the M.2 solid-state drive.
• Do not touch the contact edge or circuit board of the M.2 solid-state drive. Otherwise, the M.2 solid-state
drive might get damaged.
• Do not make the M.2 solid-state drive subject to physical shocks or vibration. Put the M.2 solid-state drive
on a soft material, such as cloth, to absorb physical shocks.
1. Disable the built-in battery. See "Disable the built-in battery" on page 58.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close the computer display and turn over the computer.
4. Remove the base cover assembly. See "Base cover assembly" on page 58.
Step 1. Remove the assembly as shown below.
64
ThinkPad X1 Carbon Gen 12 and ThinkPad X1 2-in-1 Gen 9 User Guide
and print the following instructions.