Table of Contents
Advertisement
Engine Oil
Oil and Filter Change
8. Using a cap-style oil filter
wrench, turn the filter
counter-clockwise to
remove it.
9. Using a clean dry cloth,
clean the filter sealing
surface on the crankcase.
Make sure the old filter o-
ring is completely removed.
10. Lubricate the o-ring on the
new filter with a film of
fresh engine oil. Check to
make sure the o-ring is in
good condition.
11. Install the new filter and rotate it clockwise by hand until the filter
gasket contacts the sealing surface, then turn it an additional 3/4
turn.
12. Always clean away all dirt and debris from the dipstick area before
removing the dipstick. Remove the dipstick and fill the sump with
two quarts (1.9 l) of recommended oil.
13. Reinstall and tighten the dipstick.
14. Make sure the transmission is in PARK. Apply the brakes.
15. Start the engine. Allow it to idle for one to two minutes.
16. Stop the engine. Inspect for leaks.
17. Re-check the oil level on the dipstick and add oil as necessary to
bring the level to the upper mark on the dipstick.
18. Dispose of used filter and oil properly.
MAINTENANCE
Oil Filter
93
Advertisement
Table of Contents
