Storage - Sears Craftsman 919.167621-C Owner's Manual

TO REPLACE REGULATOR
1. Release all air pressure from air
tank. See To Drain Tank in the
Maintenance section.
2. Unplug compressor.
3. Remove shrouds.
4. Remove the outlet pressure gauge
and quick connect from the
regulator.
Regulator
5. Remove the regulator.
6. Reapply pipe sealant to outlet
pressure gauge and quick
connect.
7. Assemble quick connect to new
regulator and tighten.
Before you store the air compressor,
make sure you do the following:
1. Review the Maintenance section
on the preceding pages and per-
form scheduled maintenance as
necessary.
Drain water from air tank. See To
2.
Drain Tank under Maintenance.
air tank. If not drained, water will
corrode and weaken the air tank
causing a risk of air tank rupture.
Outlet
pressure
Gauge
Quick
Connect

STORAGE

Water will
condense in the
Regulator
Nipple
Arrow
8. Apply pipe sealant tape to the
nipple.
9. Assemble the regulator. NOTE:
Arrow indicates flow of air. Make
sure it is pointing in the direction
of air flow.
10. Use the hex on quick connect
to tightening regulator. Orient as
shown.
11. Assemble outlet pressure gauge.
Orient outlet pressure gauge to
read correctly.
12. Replace shrouds.
3. Protect the electrical cord and
air hose from damage (such as
being stepped on or run over).
Wind them loosely around the
compressor handle.
4. Store the air compressor in a
clean and dry location.
17 - ENG
Quick
Connect