Lan Hardware Specification; Rs-232 Communication Setting; Lan Communication Setting; Command Message Reference - ViewSonic ViewBoard IFPG1 Series User Manual

LAN Hardware Specification

ViewSonic LFD communication port on the rear side:
1. Connector type: 8P8C RJ45
2. Pin Assignment:

RS-232 Communication Setting

• Baud Rate Select:
• Data bits:
• Parity:
• Stop Bits:

LAN Communication Setting

Type:
Protocol:
Port:
WOL Port:
Cross subnet:
Logon Credentials:

Command Message Reference

PC sends to LFD command packet followed by "CR". Every time PC sends control
command to Display, the Display shall respond as follows:
1. If the message is received correctly it will send "+" (02Bh) followed by "CR"
(00Dh)
2. If the message is received incorrectly it will send "-" (02Dh) followed by "CR"
(00Dh)
Pin # Signal
1 TX+
2 TX-
3 RX+
4 BI_D3+ For 1G case
5 BI_D3- For 1G case
6 RX-
7 BI_D4+ For 1G case
8 BI_D4- For 1G case
frame GND
9600bps (fixed)
8 bits (fixed)
None (fixed)
1 (fixed)
Ethernet
TCP/IP
5000 (fixed)
9 (fixed) for UDP
No
No
56
Output from Display
Output from Display
Input to Display
Input to Display
*3.2.0
Remark