Table of Contents
Advertisement
13
Check that the camera can detect subjects as desired using
the selected criteria.
Subjects detected by the camera are shown by green boxes
in the settings confirmation dialog.
You can choose the focus point when an option other than
[Auto-area AF] is selected for AF-area mode.
If you select [Wide-area AF (C1)] or [Wide-area AF (C2)]
for AF-area mode, you can choose the size of the focus area
by holding the focus-mode button and pressing 1, 3, 4, or
2.
You can select AF-area mode from the settings confirmation
dialog by pressing the focus-mode button and rotating the
sub-command dial.
If green boxes are not displayed as expected, press the i
button and repeat Steps 9 and 10 until the desired results
are achieved.
14
Initiate auto capture.
To initiate auto capture, press the video-record button in the
settings confirmation dialog.
Shooting will begin when a subject that meets the selected
criteria is detected and continue while the criteria are met.
Auto capture will be triggered only if all the options selected
for [Capture criteria] are satisfied.
The shooting display will turn off to save power if no
operations are performed for about three minutes, but auto
capture will remain active. The display can be reactivated
by pressing the DISP button or pressing the shutter-release
button halfway.
28
New Menu Item: "Auto Capture"
Advertisement
Table of Contents
