Advertisement
CONNECTION TO YOUR AMPLIFIER
BEFORE MAKING CONNECTIONS, MAKE SURE THAT
THE AMPLIFIER IS SWITCHED OFF.
CONNECTIONS
● Connect the push-type input terminals at the rear of the
speaker to the speaker output terminals of your amplifier
with the provided speaker cables.
● One side of the speaker cable is red and the other side is
black. Connect the (+) terminals on the amplifier and the
speaker using this red side. Connect the (–) terminals on
both components using the black side of the cable. If
connected with reversed polarity, the sound will be
unnatural and lack bass.
Procedures:
Press the tab on the terminal down, as shown in the
figure.
Insert the bare speaker wire end properly into the
terminal hole. [Remove approx. 5 mm (1/4") insulation
from the speaker cable.]
Remove your finger from the tab to allow it to lock
snugly on the cable's wire end.
Test the security of the connection by tugging lightly on
the cable at the terminal.
NS-C50
Red
Center speaker
output terminals
of the amplifier
Press tab
Black
Note
Do not let the bare speaker wires touch each other as
this could damage the speaker and/or
the amplifier.
SPECIFICATIONS
Type..........Full range acoustic-suspension speaker system
Magnetic-shielding type (EIAJ)
Speaker Unit .........................................10 cm full range x 2
Input Terminal ......................................................Push-type
Nominal Impedance..................................................6 ohms
Frequency Response...................................65 Hz – 20 kHz
Nominal Input Power.....................................................50W
Music Input Power.......................................................150W
Sensitivity ............................................................90 dB/w/m
Dimensions (WxHxD)...........................435 x 130 x 204 mm
.................................................(17-1/8" x 5-1/8" x 8-1/16")
Weight....................................................3.4 kg (7 lbs. 8 oz.)
Accessories .....................................Speaker cable (4m) x 1
* Specifications subject to change without notice due to
product improvements.
* Care should be taken not to exceed the input power
values noted above.
Velcro strip x 2
Advertisement
