Connections To Your Amplifier - Yamaha NS-AW570 Owner's Manual

CONNECTIONS TO YOUR AMPLIFIER

Before making connections, make sure that the amplifier is switched off.
Loosen
Black(-)
Speaker output
terminals of the
amplifier
Tighten
Red(+)
CONNECTIONS
•
Connect the screw-type input terminals at the
rear of the speakers to the speaker output
terminals of the amplifier (or receiver) with the
speaker cables.
•
One side of the speaker cable is red and the
other side is black. Connect the (+) terminals
on the amplifier (or receiver) and speakers
using the red side. Connect the (-) terminals on
both components using the black side of
the cable.
•
Connect each speaker making sure not to
reverse the polarity (+,-). If the speaker is
connected with reversed polarity. The sound
will be unnatural and lack bass.
How to Connect:
Loosen the knob.
Insert the bare wire. [Remove the insulation
coating at the extremity of each speaker cable
by twisting the coating off.]
Tighten the knob and secure the cable.
Test the firmness of the connection by pulling
lightly on the cable at the terminal.
Note
Do not let the bare speaker wires touch each
other as this could damage the speaker or
amplifier, or both.
When using a banana plug
Banana plug
Tighten the terminal knob.
Insert the banana plug into the terminal.
6