Troubleshooting; Using The Cord Holder - Pioneer CA-100 Operating Instructions Manual

TROUBLESHOOTING
If you think that the unit is malfunctioning, perform the following checks.
Often incorrectly following operating procedures are to blame. The cause may also lie outside the unit itself. Check
the other components and electrical appliances being used at the same time.
If the problem is not remedied after following the checklist below, contact your dealer or the nearest Pioneer Ser-
vice Center.
Remedy Trouble Possible cause
No sound from 1. Is power switch OFF?
speakers. 2. ls power cord disconnected?
3. Is tape monitor switch ON?
4. Is any connecting cord disconnected from
input or output terminal?
5. Is stereo ampilifier's ADAPTOR/
TAPE 2 switch at OFF?
6. TAPE or SOURCE input level control at
"0" position?
. Set power switch to ON.
. Connect power cord properly to
power outlet.
. Set switch to OFF.
. Connect pin plugs of cord properly.
. Set switch to ON.
. Adjust level control.
Graphic equalizer does | © Are all graphic equalizer selectors (MIC,
not function. TAPE, SOURCE) OFF?
1. Is MIC level control at minimum ''0"
position?
2. Is switch on connected microphone at
OFF?
3. Is unit's TAPE MONITOR switch at ON?
USING THE CORD HOLDER
No mic mixing.
@ As shown in the figure-below,
place the cord holder against the
left panel of the CA-100, taking
care to align the holes. Then pass
the part marked with an asterisk
(*) through the holes to secure.
Rivet
. Set switch to OFF.
Push selector corresponding to mode in
which equalization effect is to be added.
. Adjust control in accordance with
playback sound of source or tape.
. Set switch to ON.
@ As shown in the figure below,
pass all the cords connected to
the front panel over the cord
holder and secure.
Front panel
23
in esr cnc al ce g either ee ie pi eee i anc roi tear