Table of Contents
Advertisement
Watching TV
Turning On/Off the Power
ANUN
mn
POWER
Ol
(On/Standby)
disappears.
Press POWER on the TV, or POWER on the remote control
unit to turn the power on.
+ POWER indicator: Power on, Blue; Power off, red.
Press POWER on the TV, or POWER on the remote control
unit again to turn the power off.
all power
* The TV enters standby and the image on the screen
+ If you are not going to use this TV for a long period of time, be
sure to remove the AC cord from the AC outlet.
* Small amount of electric power is still consumed even when the
TV is turned off.
e If there is no signal input for 15 minutes, the power will turn to
0
6) w
When you turn on the TV for the first time, the
Setup Wizard will guide you through the setup
process. Perform the following steps before
you press POWER on the remote control unit.
1. Insert the batteries into the remote control
unit. (See page 11.)
2. Connect the antenna cable to the TV. (See
page 10.)
3. Plug in the AC cord to the AC outlet. (See
page 8.)
1. Setup Wizard---Picture Mode
* The Setup Wizard screen display at the
first use. Press A /v to select Picture
Mode.
Choose your Picture Mode
g
Home Mode(Energy Saving)
O
Store Mode
Move
(ENTER Select
MEND Exit
standby mode automatically.
Setup Wizard
Setup Wizard
Choose your Picture Mode
O
Home Mode(Energy Saving)
Y
Store Mode
Move
CA
AS
TV Location
Select "Home" or "Store" for the location where you
plan to install the TV. This product qualies for ENERGY
STAR in Home mode default setting.
Are you sure you want Home Mode?
In this mode ENERGY STAR saving are realized.
Q Yes
O
No
A
EI
E Exit
Setup Wizard
Are you sure you want Store Mode?
Selecting this Setting Does not conform to Energy Star,
Y
Yes
O
No
S Move
ENTERSelect
MEND Exit
Home Mode: "Power Saving" is set to "Yes", and AV
MODE is set to "STANDARD".
Store Mode: "Power Saving" is set to "No" and
AV MODE is set to "DYNAMIC (Fixed)".
+ ENERGY STAR qualication is based on AV MODE
"STANDARD".
®- 19
Advertisement
Table of Contents
