Installation Instructions - Monogram ZDWI240 Installation Instructions Manual

STEP 1 REMOVE PACKAGING
• Remove corner blocks and foam drawer stops.
• Remove all packing material, tape and protective
plastic coverings.
• Remove stainless steel toekick taped to the back of the
unit.
WARNING
Small objects are a choke hazard for
children. Remove and discard any parts not used.
AVERTISSEMENT
étrangler les enfants. Il faut jeter toutes les pièces qui ne
sont pas utilisées.
STEP 2 REVERSE DOOR SWING
SKIP THIS STEP IF DOOR SWING SUITS THE
INSTALLATION
WARNING
Follow all steps when reversing the
door swing. Failure to follow these instructions, leaving
off parts, or over tightening screws, can lead to the door
falling off and result in injury and property damage.
AVERTISSEMENT
Suivez toutes les étapes lors du
changement d'ouverture de la porte. La porte risque de
tomber en plus de causer des blessures ou des dommages
si vous ne respectez pas ces instructions, oubliez des
Parts Included:
• Top left case hinge
• Bottom left case hinge
• Left and right side decorative hinge cover
• Decorative hinge screw hole cover
• Torx ® driver bit
Tools Required:
• Phillips screwdriver
• Electric drill
Remove the door:
• Flatten the shipping carton to use as a pad.
• Remove the 2 screws and the toekick. Set aside the
• Use the supplied Torx ®
hinge. (Screws will be used to install the new hinge.)
• Remove the bottom case hinge pin and bracket.
Rotate the door:
The handle will be on the right side of the door; hinges
will be installed on the left side of the case.
• Remove the door stop and cam riser on the original
bottom right side of the door.
left side.
31-1000646-2

Installation Instructions

Les petits objets peuvent
bit and electric drill to remove
STEP 2 REVERSE DOOR SWING
(Cont.)
Reinstall the door:
• Install the original door stop and cam riser onto the
bottom left side of the door.
• Install the new supplied bottom case hinge pin and
bracket onto bottom left side.
• Place the door onto the bottom case hinge.
• Install the supplied left-hand top case hinge with the 3
original screws.
• Select the hinge cover marked with an "L".
cover.
• Press and snap the hinge cover into place.
• Snap the screw hole cover into place on the opposite
side.
Install Covers
IMPORTANT:
Check to be sure screws are tight and that the door is
straight and does not sag. The door should swing freely.
Install
3 Hinge
Screws
Door Stop
and Cam Riser
Remove
Top Hinge
Hinge
Pin and
Bracket
Remove
Hinge
9