KTM 250 SX 2003 Owner's Handbook Manual page 71

3-5
2
3
Dismounting of kickstarter
– Remove circlip
– Carefully release collar bolt
tension on kickstarter spring and unhook spring hanger.
C
AREFULLY RELEASE THE KICKSTARTER SPRING
– Pull the kickstarter shaft together with ratchet gear, spring, and disc
out of the engine casing.
– Take care of the stop disc, which could stay in the housing.
1
Dismounting of the shift lock
– Press the sliding plate
engages with the driver for the shaft roller, at the same time remove
shift shaft from the housing.
NOTE: Watch the stop disc which remains in the housing.
– Loosen the AH bolt
4
NOTE: Disassemble locating lever only if the engine case must be
replaced.
5
– Remove bolt
Dismounting of ignition cover
– Undo the 4 bolts and remove the ignition cover together with the
gasket.
1
and kickstarter intermediate gear.
2
kickstarter spring is tensioned, release
CAUTION
!
! D
3
back with a bolt driver so it no longer
4
and remove the shift lock.
5
and locking lever with spring and bush.
!
!
ANGER OF INJURY