Table of Contents
Advertisement
Chapter 4
Dismantling / Cleaning
Dismantling DH / DS
Item
Part to remove
7
Woodruff key
3
Seal plugs
14, 15 Drain plug, washer (if
present)
16, 17 Screws, washers
12
End cover
9, 11
Gear wheel set, O-rings
(2 off )
8
Cardan shaft
9, 10
Distributor plate, O-ring
2
Output shaft
5, 6
O-ring, bearing race
5
Shaft seal
3
Dust seal
Cleaning
Cleaning
Clean all parts carefully with low aromatic kerosine.
Inspection and replacement
Check all parts carefully and replace if necessary.
Lubrication
Before assembly, lubricate all parts with hydraulic oil and grease rubber parts with vaseline.
WHITE can accept no responsibility for possible errors in catalogues, brochures, and other printed material. WHITE reserves the right to alter its products without notice. This also applies to products already on
order provided that such alterations can be made without subsequent changes being necessary in specifications already agreed.
All trademarks in this material are the property of the respective companies. WHITE and the WHITE logotype are trademarks of WHITE Drive Motors & Steering LLC and WHITE Drive Motors and Steering Sp. z o.o..
Comments
Put the motor in a holding tool, with the output shaft downward
Use a 17 mm spanner socket.
Use a 13 mm spanner socket.
Remove end cover sideways
Keep fingers under the gearwheel set to prevent the parts from
falling out
Place the motor housing on the work bench and press the shaft
out of the motor housing. After this, turn the motor
Remove bearing and bearing race from the motor housing
With mandrel and plastic hammer, carefully knock out the shaft
seal
Table 4: Dismantling DH / DS
All rights reserved.
12
Advertisement
Table of Contents
