Roland EF-303 Owner's Manual page 48

Using the EF-303 with External MIDI Devices
Selecting patches from an external
MIDI device
You can switch patches by transmitting Program Change
(PC) messages from an external MIDI device to the EF-303.
To do this, the Receive Program Change Switch (r.PC) setting
must be "ON."
MIDI transmit/receive settings (TX/RX) (p. 55)
For details on transmitting Program Changes from an
external MIDI device, refer to the manual for your device.
Using the EF-303 to control an
external MIDI device
The EF-303 can transmit operations of its knobs or sliders
from its MIDI OUT connector.
Бу setting the channel of the receiving external MIDI device
to the same setting of the MIDI channel of the EF-303, you
can play the external MIDI device.
1. Setthe MIDI channel of the external sound module to
match the MIDI channel of the EF-303.
2. Setthe EF-303's "Knob destination setting" and "Slider
destination setting" to "EXT."
With these settings, performance data will be transmitted
from MIDI OUT.
Knob destination settings (p. 53)
Slider destination setting (p. 54)
3. Play back the EF-303's step modulator or operate its
knobs and sliders.
MIDI OUT MIDI IN
o
0 EIER
„ШШШ a=
ojo ООООООООЈ оо
есососооо (J
EF-303
Synchronizing with an external
MIDI device
The step modulator of the EF-303 can play back in
synchronization with another sequencer.
Synchronizing an external sequencer
to the playback of the EF-303
An external MIDI sequencer can be made to synchronize to
the MIDI Clock messages transmitted from the EF-303, so
that it will play back in synchronization. Here's how to
synchronize an external MIDI sequencer to a pattern of the
EF-303.
Зедепсег
(SLAVE)
MIDI IN
Synchronization signal
MIDI QUT
EF-303
(MASTER)
ojo ОООООООО) ве
е oooooooo Ц
—
1. Set SYNC OUT to "ON."
ІС"
Synchronization message transmission (Sync Out)
setting (p. 54)
With this setting, synchronization messages will be
transmitted from the EF-303's MIDI OUT.
2. For the "Knob/slider-related settings (CTRL)," set both
"Knob destination setting" and "Slider destination
setting" lo "INT." With these settings, only
synchronization data and Start and Stop commands will
be transmitted from the EF-303's MIDI OUT.
БӨ"
Knob destination settings (p. 53)
Dx
Slider destination setting (p. 54)
3. Sel your external MIDI sequencer so that it will
synchronize to MIDI Clock messages that it receives. For
details on making this setting, refer to the owner's
manual for your external MIDI sequencer.
48