Genera! Care & Cleaning; Beforeyou Cait - Kenmore PRO 790.42003 Use & Care Manual

Electric built-in oven
Table of Contents

Advertisement

Before You Call
Solutions
to Common
Problems
Before you call for service,
review this Hst, it may save you time and expense, The Hst inciudes common occurrences that
are not the resuit of defective workmanship or materiais in this appliance,
OCCURRENCE
POSStBLE
CAUSE/SOLUTmON
Oven Control Seeps and DispJays
EHectronb controi has detected a fauit condition, Press any key to dear the
any F code error (example Fll).
dispiay and stop the beeping, Reprogram the oven, if a fauit reoccurs, record
the fauit number, Press any key and cali Sears or another qualified servicer,
"d-o" is displayed.
The door was Heftopen and controis set for seif-cieaning cycie,
Just chose the door to correct the probiem,
AppJiance not tevet.
Piace oven rack in center of oven, Piace a ievei on the oven rack, Contact
Poor cooking
results,
installing agent if rack and cabinet cutout flooring are not ievei,
Kitchen cabinet misalignment may make oven appear to be not level, Be sure
cabinets are square and level, Contact cabinet maker to correct problem,
Entire oven does not operate.
When the oven is first plugged in, or when the power supply to the oven has
been interrupted, the display wiii flash, The oven cannot be programmed until
the clock is set,
Be sure electrical cord is securely connected into the electrical junction box,
Cord/plug is not installed and/or connected, Cord is not supplied with oven,
Contact Sears or another qualified servicer,
Service wiring not complete, Contact Sears or another qualified servicer,
Power outage, Check house lights to be sure, Call your local electric company,
Short in cord/plug, Replace cord/plug,
Controls are not set properly, See instructions under Setting Oven Controls
to
set the controls,
House fuse has blown or circuit breaker has tripped immediately following
installation, House fuse may not be fully engaged, Check fuse and screw or
engage circuit breaker securely,
House fuse has blown or circuit breaker has tripped after the oven has been
installed and previously operating, Contact Sears or another qualified servicer,
Oven tight does not work.
Burned-out or loose bulb, Follow the instructions under Changing
Oven Light
to replace or tighten the bulb,
Fan noise during cooking
operation.
A cooling fan may automatically
turn on and off to cool internal parts, This is
normal, and the fan may continue to run even after oven is turned off,
in self-clean mode, the blower in both ovens will start when using one of the
ovens,
18

Advertisement

Table of Contents
loading

Table of Contents