Impedance Selector Switch - Yamaha RX-V730RDS Owner's Manual

SPEAKER SETUP
I IMPEDANCE SELECTOR switch
WARNING
Do not change setting of the IMPEDANCE SELECTOR switch when the power of this unit is on, this may damage
the unit. If this unit fails to turn on when STANDBY/ON (or SYSTEM POWER) is pressed, the IMPEDANCE
SELECTOR switch may not be fully slid to either position. If so, slide the switch all the way to either position when
this unit is in the standby mode.
Select the switch position (left or right) according to the impedance of the speakers in your system. Be sure to move this
switch only when this unit is in the standby mode.
MAIN
A OR B :4 MIN. /SPEAKER
:8
A+B MIN. /SPEAKER
:6
CENTER MIN. /SPEAKER
REAR CENTER
:6
MIN. /SPEAKER
REAR :6 MIN. /SPEAKER
SPEAKERS
MAIN REAR CENTER
R L
+
A
–
–
OMPONENT VIDEO
B
/C P /C Y
R R B B
+
R L R
OUTPUT
R L
MAIN
:
MAIN A OR B 8 MIN. /SPEAKER
:
A+B 16 MIN. /SPEAKER
MAIN
:
:4 CENTER 8 MIN. /SPEAKER
A OR B MIN. /SPEAKER
:8 :
A+B MIN. /SPEAKER REAR CENTER 8 MIN. /SPEAKER
:6 MIN. /SPEAKER :
CENTER REAR 8 MIN. /SPEAKER
REAR CENTER
:6 MIN. /SPEAKER
REAR :6 MIN. /SPEAKER
SET BEFORE POWER ON
IMPEDANCE SELECTOR
(U.S.A. model)
12
IMPEDANCE
SELECTOR
switch
:
MAIN A OR B 8 MIN. /SPEAKER
:
A+B 16 MIN. /SPEAKER
:
CENTER 8 MIN. /SPEAKER
:
MIN. /SPEAKER
REAR CENTER 8
:
MIN. /SPEAKER
REAR 8
SET BEFORE POWER ON
IMPEDANCE SELECTOR
CENTER
+ +
– –
–
+
REAR
L
(SURROUND)
REAR
CENTER
CENTER
REAR
L
R
(SURROUND)
Switch Speaker
position
If you use one set of main speakers,
the impedance of each speaker must
be 4 Ω or higher.
Main
If you use two sets of main speakers,
the impedance of each speaker must
be 8 Ω or higher.
The impedance must be 6 Ω or
Left Center
higher.
The impedance must be 6 Ω or
Rear
Center higher.
Rear The impedance of each speaker must
be 6 Ω or higher.
If you use one set of main speakers,
the impedance of each speaker must
be 8 Ω or higher.
If you use two sets of main speakers,
Main the impedance of each speaker must
be 16 Ω or higher.
[Canada model only]
The impedance of each speaker must
be 8 Ω or higher.
Right
The impedance must be 8 Ω or
Center
higher.
The impedance must be 8 Ω or
Rear
Center higher.
Rear The impedance of each speaker must
be 8 Ω or higher.
Impedance level