Connecting Speakers - Yamaha RX-V293 Owner's Manual

CONNECTING SPEAKERS

Rear speaker
Right
How to Connect:
Connect the SPEAKERS terminals to your speakers with wire of the proper gauge (cut as short as possible). If the connections are
faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is the + and –
markings are observed. If these wires are reversed, the sound will be unnatural and lack bass.
Caution
Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit and/or
speakers.
For connecting to the MAIN SPEAKERS terminals
Red: positive (+)
Black: negative (–)
Center speaker Rear speaker
SPEAKERS
REAR CENTER REAR
REAR
SINGLE
CAUTION
SEE INSTRUCTION MANUAL FOR CORRECT SETTING.
MAIN
Press the tab.
Insert the bare wire.
[Remove approx. 5mm
(1/4") insulation from
the speaker wires.]
Release the tab and
secure the wire.
Note
Use speakers with the specified impedance
shown on the rear of this unit.
Left
(U.S.A. model)
IMPEDANCE SELECTOR
SET BEFORE POWER ON
REAR SINGLE:6 MIN. /SPEAKER
DUAL:3 MIN. /SPEAKER
CENTER 6 MIN. /SPEAKER
MAIN 4 MIN. /SPEAKER
REAR SINGLE:8 MIN. /SPEAKER
DUAL:4 MIN. /SPEAKER
CENTER 8 MIN. /SPEAKER
MAIN 8 MIN. /SPEAKER
Main speakers
Left
For connecting to the REAR and CENTER SPEAKERS
terminals
Red: positive (+)
Black: negative (–)
Right
Press the tab.
Insert the bare wire.
[Remove approx. 5mm
(1/4") insulation from
the speaker wires.]
Release the tab and
secure the wire.
9