Dometic CK Series Short Operating Manual page 10

• Disconnect the cooling device from the power
supply
– Before each cleaning and maintenance
– After every use
Health hazard
To avoid contamination of food, observe the
following instructions:
• Check if the cooling capacity of the device is
suitable for storing the food to be cooled.
• Food may only be stored in its original packag-
ing or in suitable containers.
• Opening the cooling device for long periods of
time can cause significant increase of the tem-
perature in the compartments of the device.
• Clean regularly surfaces that can come in contact
with food and accessible drainage systems.
• If the device is left empty for long periods:
– Switch off the device.
– Defrost the device.
– Clean and dry the device.
– Leave the lid open to prevent mold develop-
ing within the device.
A
NOTICE! Damage hazard
• Check that the voltage specification on the data
plate corresponds to that of the energy supply.
• Only connect the cooling device to a DC power
supply in the vehicle with the DC connection
cable.
• Connect the cooling device to an AC power
supply with the AC connection cable.
• Never pull the plug out of the socket by the
cable.
• Disconnect the cooling device and other power
consuming devices from the battery before con-
necting a quick charging device.
• Disconnect the cooling device or switch it off
when turning off the engine. Otherwise the bat-
tery may be discharged.
• The cooling device is not suitable for transport-
ing caustic materials or materials containing sol-
vents.
• The insulation of the cooling device contains
flammable cyclopentane and requires special
disposal procedures. Deliver the cooling device
at the end of its life-cycle to an appropriate
recycling center.
• Do not place the cooling device near naked
flames or other heat sources (heaters, direct sun-
light, gas ovens etc.).
10
• Risk of overheating!
Ensure at all times that there is a minimum of
50 mm ventilation on all sides of the cooling
device. Keep the ventilation area free of any
objects that could obstruct the air flow to the
cooling components.
Do not use or store the cooling device in closed
compartments or areas with none or minimal air
flow.
• Do not fill the inner container with ice or fluids.
• Never immerse the cooling device in water.
• Protect the cooling device and cables against
heat and moisture.
• The device shall not to be exposed to rain.
Safety when operating with gas
!
WARNING! Failure to obey these
warnings could result in death or
serious injury.
Explosion hazard
• Only operate the device at the pressure shown
on the type plate. Only use pressure controllers
with a fixed setting which comply with the
national regulations.
• Never operate the device with gas:
– At petrol stations
– In parking garages
– On ferries
– While driving
• Never use a naked flame to check the device for
leaks.
• In case of gas odor:
– Close the gas supply cock and the valve on
the cylinder.
– Do not press an electric switch.
– Put out any naked flames.
• Have the gas system checked by a specialist.
4445103833
EN