Advertisement
8
Bend the tip of the film leader towards the
emulsion side and insert into the take-up spool
as indicated by the diagram inside the camera.
Wind the film leader tightly 3 or 4 times around
the spool.
9
Place the take-up spool on the take-up spooi
shaft.
4 Be sure to check that the pressure plate and
the film holder are in the normal positions and the
knobs are dropped in.
(See the picture in the
following page.)
1
||
Press the shutter release button, while press-
I U ing the film guide release pin (the film guide
is in open condition), and check to see that the
top and bottom film loops are uniform.
About
one second, or 10 to 15cm, of film feed is suffi¬
cient.
n
Put the side cover back on, turn the film side
cover latch and flip it down.
4
The film holder on the take-up sprocket must
be at the correct position in order to close the side
cover properly.
Advertisement
