Disassembly Of Shaft Unit A - Technics SU-C500EB Service Manual

8.22. Disassembly of Shaft Unit A

• Refer to "Disassembly of Rear Panel".
• Refer to "Disassembly of Side AL Panel L & R".
• Refer to "Disassembly of Bottom Chassis".
• Refer to "Disassembly of Front Panel Block".
• Refer to "Disassembly of SMPS P.C.B.".
• Refer to "Disassembly of AMP P.C.B.".
Step 1 Remove 3 screws.
Step 2 Detach 3P Cable at the connector (P5002) on Main
P.C.B..
Step 3 Remove Rail Holder Unit.
Step 4 Remove screw.
Step 5 Remove Interlock SW P.C.B..
Step 6 Remove screw.
Step 7 Remove Spring.
Step 8 Remove screw.
Step 9 Remove Spring Support.
Step 10 Remove Screw Spacer.
Note for assembling:
After removing the adhesive for screw lock cleanly from the
Screw Spacer and the screw hole of Shaft Unit A, tighten up to
the fastening torque: 7k
If some dusts of the adhesive for screw lock remains between
Shaft Unit A and shaft plate, it may cause the operation failure
or abnormal noise while opening/closing the CD cover.
Step 11 Remove Guide Holder.
55
g
·
f cm.